BuildersPlanet.comBuildersPlanet Home Page
Marketplace Job Bank Buy/Sell Community News Services
 HOME  >  Job Bank >  The Quiz  >  Quiz Part3 Instant Feedback

TAKE THE QUIZ!

So you think your a well rounded tradesman huh?
This is an actual test that a remodeling contractor used to screen new employees.
Only one person ever aced it and got 100%
Boyd Nelson of Los Osos, California.
Take the test and you'll get the results back in seconds

There are   4  parts with 13 questions each.
Part 1   :   Part2   :   Part3   :   Part4   :   All 51  :   Get the next 12 questions

Come on give it a try! Your one smart cookie Sorry try again.

Submit A Question

27. A single story stem wall footing should be a minimum of  how wide?     
18"
12"
24"
36"
28. What diameter is #4 rebar?
4"
3/4"
1/2"
1/4"
29. An under floor crawl space should be a minimum ofhow tall?
18"
24"
6"
36"
30. An access hole to an attic or under floor should be minimum how big?
18" X 18"
24" X 24"
36" X 36"
18" X 24"
31. A typical asphalt shingle has how many "tabs"?
4
8
3
1
32. When installing roofing felt horizontal and vertical laps should be how large respectively?
4" and 12"
6" and 6"
2" and 6"
3" and 12"
33. What are two kinds of tile bullnose?
quarter and edge
surface and radius
flat and round
edge and flat
34. Tile joints smaller than 1/8" and joints larger that 1/8" should use what kind of grout respectively?
sanded and unsanded
rough and smooth
poly sorbate and poly carbate
unsanded and sanded
35. Typical framing lumber in California is?
Redwood
Pine
Douglas Fir
Walnut
36. Drywall on center nailing pattern on walls is?
8" in the field and 7" on edges.
9" in the field and 9" on edges.
12" in the field and 6" on edges.
6" in the field and 12" on edges.
37. Drywall on center screw pattern on walls is?
12" in the field and 6" on edges.
6" in the field and 12" on edges.
8" in the field and 7" on edges.
16" in the field and 12" on edges.
38.What is a drywall banjo?
used for mixing compound.
a drywall taping machine.
music from a drywall square.
a tool for cutting circles in sheet rock .
39. A header under 8' long is typically cut how much larger than the rough opening?
the same size
6 inches.
3 inches.
8 inches.

     Get the next 12 questions

Submit A Question


Home|Marketplace|Buy Sell|Job Bank|Community|News|Service|Contact Us

© 2000 BuildersPlanet All rights reserved
By using this site you accept our terms  and privacy policy.
For comments or problems, email Webmaster@buildersplanet.com or call 831-335-0475